TSURUGA MODEL 460A
Quantity
Pulse Counter
- ¡ö DIN 96×48 mm size, compact design.
- ¡ö Build-in sensor power supply. (DC 12 V, 100 mA)
- ¡ö Back up count data by EEPROM.
- Model Designation
-
460A - ¡õ - ¡õ - ¡õ - ¡õ ¢Ù ¢Ú ¢Û ¢Ü General Specifications
Display 0 to 999999 red or green LED (character height 15 mm) with zero-suppress function.
Decimal Point can be arbitrarily set (front setting or external control).
Over-range indication by flashing of LED at lower left of the display section.Counter input Maximum counting speed 10 Hz / 5 kHz (10 cps / 5 kcps) by selection of input terminal. Minimum pulse width 50ms at 10 Hz (cps), 0.1ms at 5 kHz (kcps) Memory retention By non-volatile memory for approximately 10 years. Sensor power DC 12 V ± 5% 100 mA BCD data output TTL level, isolation output (BP: positive logic, BN: negative logic)
Data output: Parallel BCD code, latch output, TTL level (CMOS compatible), Fo = 2
Control output: OVER (at over: logic1)
Control Signal: LATCH, RESET, Decimal Point (Active “L”), Data Enable (Active “H”)
Transistor, isolation output (DP: Source type, DN: Sink type)
Output capacity: DC30V 30mA Max
Data output: Parallel BCD code, latch output, transistor “ON” with “1”, transistor “OFF” with “0”
Control output: OVER (at over: “ON”)
Control Signal: LATCH, RESET, Decimal Point (Active “ON”), Data Enable (Active “OFF”)Withstand voltage Input terminals – external case: AC 1500 V for 1min.
Power supply terminals – external case: AC 1500 V for 1min.
Power supply terminals - Input terminals: AC 1500 V for 1min.
Input terminals - Data output terminals: AC 500 V for 1min.Insulation resistance DC 500 V More than 100 MΩ Power supply AC 100 to 240 V 50/60 Hz Approx. 9 VA DC 24 V Approx. 200 mA Tolerance of source voltage AC 90 to 250 V, DC 24 V ± 10% Operating temperature 0 to 50°C Storage temperature -20 to 70°C Weight Approx. 500 g
